1
MAX
2
3
4
5
After extracting,
tighten the bolts
temporarily.
(Fig. A)
Loosen two
M6x15 bolts
of the Lock
Plates, move
them to the
mid zone of
the Center
Pillar and
hold. (Fig. B)
Loosen both
M6x15 and
M6x20 bolts
to move the
lower Pillar
Joint upward.
(Fig. C)
MAX Decal
Please be sure
the MAX
decal is put on
both top and
bottom end
of the Center
Pillar.
This tells you
need to insert
the Center
Pillar into the
Upper or the
Lower Pillar
in the depth
at least this
red indicator
becomes
invisible for
your safety.
(Fig. D)
MAX
!
The Lower Pillar must be fully inserted
into the Pillar Joint.
If some clearance remains, the pillar
may be too short and could fall down,
causing a serious accident.
Insert the
Center Pillar
into the Lower
Pillar. (Fig. E)
Make sure the
top end of the
Lower Pillar
comes until
the end of the
Pillar Joint
plastic sleeve.
(Fig. F)
Tighten both
M6x15 and
M6x20 bolts on
the lower Pillar
Joint with the
tightening
torque 8 N.m to
fix the position.
Same
length
is the
best
○
×
Not
good
8 N.m
The total
pillar length
adjustment will
be done on the
Upper Pillar
side only.
So leave the
upper Pillar
Joint as it is
temporarily
tightened.
- 2 -
About Center Pillar Insertion Depth
The BikeTower25D is constructed with two fatter pillars and single
narrower pillar combination.
The center pillar must be inserted into the upper or lower pillar at
least in the depth until the MAX decal becomes invisible. In this
condition, the pillar will have enough strength to support the load.
We strongly recommend you to insert the center pillar into both
the upper and lower pillars in the same length that would provide
maximum stability.
If the center pillar is not inserted evenly into the upper and lower
pillars, the balance of the stand will be off and could compromise
the overall stability of the stand.
For your reference, if your room's ceiling height is 2.4 meters (7.9'),
you should insert the center pillar in the depth of 25 centimeters (10").
It will give you the proper insertion ratio.
MAX
Calculation Of Tightening Torque
75 mm
If the hex wrench length is 75mm,
pull the wrench tip with the power
of 107N (11 kgf) to expect 8 N.m
tightening torque.
Pull with 107N power
How To Setup
Measurement
→
Temporarily Setting
→
Adjusting Length
→
Setting
→
Check
→
Fix
Required Tool :
5mm Hex Wrench
The Upper
and Lower
Pillars come
separated.
The Center
Pillar is
retracted inside
the Upper
Pillar.
Loosen the
M6x20 bolt of
the Metal Ring
on the upper
Pillar Joint
to extract the
Center Pillar.
Loosen
Extract
(Fig. A)
Move
Loosen
(Fig. B)
Move
Loosen
(Fig. C)
(Fig. D)
Tighten
(Fig. E)
(Fig. F)
Insert
(Fig. G)
8 N.m
