Minolta CL-200, Инструкция по эксплуатации

Страница: 19 / 56

17
3. Open the slide cover, and press [ SET ].
◆
The CHROMA METER enters SET mode, and the dis-
play appears as shown in the illustration.
◆
The measurement results that you held at Step 1 above
now blink on the display.
●
If you wish to cancel without registering the blinking val-
ues as your new target, press [
CALL ].
4. Press [ SET ] again.
◆
The CHROMA METER writes the measured values into
the target memory, so that they become the current tar-
get values. The displayed values accordingly change to
“
±
0” (where the number of digits on each line varies ac-
cording the display mode), since the measured values
and target values are now identical.
●
You can review the target values at any time by holding down the [ CALL ] key. The values
remain on the screen until you release the key.
●
When taking the measurement for the target value, please use the same display mode
that you intend to use when taking the color difference measurements. Changing the
display mode after measuring the target may result in errors in the difference results. (If
you are going to measure color difference using
∆
Ev
∆
x
∆
y mode, take the target meas-
urement using Ev x y mode.)
2 2 2 2 2 Manually Keying in the Target Values
The following procedure takes you through the steps necessary to manually enter target
values when using
∆
E
∆
x
∆
y display mode. The entry procedure for other display modes is
essentially the same.
1. Press the [ MODE ] key (to set the CHROMA METER into color-
measurement mode, page 14), and pop out the HOLD button (into
RUN position).
All values become
±
0.