E-9
2. Plug the power cord into the power outlet.
XIV. Clearing the counters
1. Turn ON the Power Switch.
Note:
Though the control panel displays the message
that informs you that the right door is open, ignore
the message and perform the following steps.
2. Display the Service Mode screen. (For details of
how to display the Service Mode, see the service
manual.)
3. Touch “Supplies”
o
“Life Counter Clear”.
4. Touch “Drum Unit (K)”.
The message “Are you sure?” will appear. Touch
“OK”.
5. Take similar actions as step 4 for the following
items:
• Developing Unit (K)
• Developer (K)
6. Touch “Close” twice.
XV. TCR sensor adjustment
1. Close the right door.
2. Make sure that the Service Mode screen is dis-
played.
3. Touch “Printer Adjustment”
o
“TCR Sensor
Adjustment”.
4. Touch “Execute”
o
“OK”.
Note:
After touching “OK”, wait about 1 minute 30 sec-
onds as is.
5. Touch “Close”.
6. Touch “Close” on the Service Mode screen.
XVI. Installing the toner bottle
Note:
The toner bottle is not shipped with the machine.
Purchase one that is separately available.
1. From a height of about 10 cm, tap the toner bottle
against a table or other hard object four to five
times. Then turn it upside down and repeat the
same procedure.
Note:
Toner can be caked in the toner bottle. Be sure to
perform this procedure.
2. Shake the toner bottle well about five times in the
vertical direction. Then, turn it over and repeat
the same procedure.
3. To move toner to the toner supply port side in the
bottle, drop the toner bottle with the supply port
side down onto a table or other hard surface from
the height of about 10 cm several times.
C4004U139CA
1166O228AA
1166O095AA
A1UDIXC049DA
