Minnich A-1-24, Руководство оператора и сервисное руководство

Страница: 23 / 28

23
Dowel Drill Manual
PRESSURE REGULATOR
MINNICH P/N 013089-00000
SPECIFICATIONS
Fluid: Compressed air
Maximum inlet pressure: 300 psig (20.7 bar)
Temperature range: Oo to 170oF (-18o to 79oC)
Air supply must be dry enough to avoid ice formation at temperatures be-
low 35oF (2oC). Gauge ports: 1/4” (0.64cm)
MATERIALS OF CONSTRUCTION
Body: Aluminum
Bonnet: Aluminum
Bottom Plug: Acetal
Valve: Brass
Elastomer: Nitrite
WARNING
These products are intended for use in industrial compressed air systems only.
Do not use these products were pressures and temperatures can exceed those
listed under specifications
If outlet pressure in excess of the regulator pressure setting could cause down-
stream equipment to rupture or malfunction, install a pressure relief device
downstream of the regulator. The relief pressure and flow capacity of the relief
device must satisfy system requirements.
The accuracy of the indication of pressure gages can change, both during ship-
ment (despite care in package) and during the service life. If a pressure gauge is
to be used with these products and if inaccurate indications may be hazardous
to personnel or property, the gauge should be calibrated before initial initializa-
tion and at regular intervals during use. For gauge standards refer to ANSI B40.
1.
DISASSEMBLY
1. Shut off inlet pressure. Reduce pressure in inlet and outlet lines to zero. Turn
adjustment 2A fully counterclockwise.
2. Regulator can be disassembled without removal from air line. Disassemble as
shown on the exploded view.
CLEANING
1. Clean parts with warm water and soap.
2. Rinse or dry parts.
3. Blow out internal passages in body with clean, dry compressed air.
4. Inspect parts. Replace parts found to be damaged.
ASSEMBLY
1. Lubricate the following items with a light coat of o-ring grease.
- All o-rings, valve stem (17), valve bore in bottom plug (14),
-Adjusting screw tip and adjusting screw threads inside bonnet (9), threads on
bonnets (9) and bottom plug (14)
2. Assemble the regulator as shown on the exploded view.
SERVICE KIT P/N 0962-00011
Includes (13, 15, 16, 17, 18)
SERVICE KIT INSTILLATION
Repair kits are universal and may contain parts not used on your regulator. Al-
ways replace used parts with identical parts. Discard kit parts not used on your
regulator.