minnkotamotors.com
INSTALLATION
19
minnkotamotors.com
2.
On the front control panel of the Talon are three (3) switches:
an Auto UP switch
, an Auto DOWN switch
and a Rough Water switch
.
3.
If using a battery selector/Perko-type switch, turn the selector switch to the
“on” position.
4.
Standing clear of the Talon, push the Auto DOWN switch.
a. The Talon Spike will begin to deploy.
b. When the Spike comes in contact with the ground, the unit will
automatically shut off. After the initial shut off, you will hear two (2)
additional deploy cycles (or clicks), each 3-seconds apart from the initial
ground contact.
c. The Front Panel will display approximately
(1) LED light for each foot of Spike
deployed. (Figure 23)
d. If the above steps were successful, push the
Auto UP switch
. The unit will fully
retract to the stowed position. No LED lights
will be displayed. (Figure 24)
e. If the above steps were not
successful, please see the trouble
shooting guide on pages 26-27 in the Talon
Owners Manual.
f. To perform the same test using the remote
instead of the buttons on the control panel,
double click the remote DOWN button
to deploy, and
single click the remote UP button
to retract.
FIGURE 23
FIGURE 24
