INSTALLING AN ExTERNAL TRANSDUCER
c. Rotate the Latch Collar so it fits comfortably
within the hold of the Deploy Assist Lever.
d. Re-tighten the screw to secure the Latch Collar
in place.
2
Installing an External Transducer
Your trolling motor may be pre-installed with a Universal Sonar transducer system. For compatibility and more information
on Universal Sonar. An external transducer is not included with your trolling motor. An external transducer can be installed
onto the motor.
a. Mount the External Transducer according to
directions provided with the transducer.
b. Leave enough slack in the Transducer Cable
between the Lower Unit and Motor Control Head
to allow the motor to properly stow and deploy.
c. Use two tie wrap cables to secure the Transducer
Cable to the Shaft just above the Latch Collar and
just below the Motor Control Head.
d. Run the Transducer Cable through the Coil Cord
to the fish finder.
1
Slack
Tie Wrap Cable
Latch Collar
Lower Unit
Tie Wrap Cable
External Transducer
Transducer Cable
Coil Cord
Motor Control Head
Latch Collar
Screw
CAUTION
Not following the recommended wire routing for the
External Transducer may cause damage to the product
and void your product warranty. Take care to test the
length and placement of cable to be sure that there is
enough slack where needed and that cables are free of
being entangled in moving parts. Routing the cables in
any way other than directed may cause damage to the
cables by being pinched or severed.
