(Optional Accessory Kit #1820089 - not included)
minnkotamotors.com | 13
©2017 Johnson Outdoors Marine Electronics, Inc.
OPTIONAL INSTALLATION
Item /
Assembly
Part #
Description
Qty.
1
✖
15FT EXTENSION CABLE
1
2
✖
WIRE SPLICE
2
3
✖
ADHESIVE HEAT SHRINK
2
✖
This part is included in an assembly and cannot be ordered individually.
INSTALLING THE MK-EC EXTENSION CABLE ACCESSORY
The Minn Kota Battery Charger Output Extension Cables are ideal for extending charger output cables that do not reach bow,
center or transom battery compartments. Featuring easy installation with waterproof adhesive heat shrink for use in saltwater
environments. Each conductor is fused for protection against accidental short circuits.
INSTALLATION PARTS LIST
1
3
2
•
Wire Cutters
•
Wire Strippers
•
Crimpers
•
Heat Gun
TOOLS AND RESOURCES REQUIRED
INSTALLATION
a. Remove AC power from your charger and
disconnect the charger from ALL batteries.
b. Open the door or hatch of the compartment
and allow it to air out for 15 minutes. This
allows any gasses that have accumulated in the
compartment to escape.
c. Find the charger output cable you would like to
extend and use the wire cutters to cut the red or
white (positive) and black (negative) wires before
the fuse holders.
1
NOTE:
Some output cables will have a
temperature sensor in the cable covered by heat
shrink. You must cut above the temperature
sensor to avoid damaging the sensor.
Temperature Sensor
Cut Here
