INSTALLATION
6
7
j. Once lifted, using a #3 Screwdriver, remove the
single screw holding the Strain Relief Bracket in
place.
k. Release the Power Cable and Motor Cable Plug
from the Strain Relief Bracket.
l. Connect the Motor Cable Plug that was
previously connected to the Foot Pedal to the
CoPilot receiver Power Connection that has the
female receptacles.
m. The Foot Pedal Connection from the CoPilot
receiver can be connected to the Foot Pedal once
the installation is complete.
n. Place the Power Cable and the Foot Pedal
Connection from the CoPilot Receiver on the
Base Extrusion so that it can be captured in the
Strain Relief Bracket.
o. Using a #3 Screwdriver, replace the screw that
was holding the Strain Relief Bracket in place.
p. Be sure that the wires are routed in a way that
they can not be pinched and reseat the Center
Housing in place.
NOTE:
The wires should pass under the
Center Housing over the Base Extrusion in the
notch that creates a separation from the base
and the housing. The connection between the
Motor Cable Plug and the Power Connection
should be under the Center Housing when it is
seated.
Strain Relief Bracket
Screw
6j
6l
Power Cable
Power Cable
Foot Pedal
Connection
Foot Pedal
Connection
Motor Cable Plug
Motor Cable Plug
Power
Connection
Power
Connection
Base Extrusion
Base Extrusion
Strain Relief Bracket
Screw
7o
7p
Power
Connection
Foot Pedal
Connection
Power
Cable
Center
Housing