INSTALLATION
5
g. With the Right Sideplate laying flat, and the
CoPilot receiver that was just installed facing
upwards, route the yellow wire antenna around
the pegs protruding from the Right Sideplate
along the right and bottom edge of the CoPilot
Receiver. Follow the grooves in each of the pegs.
h. Deploy the motor.
i. On the mount, lift the Center Housing to access
the components below. The Center Housing can
be released by depressing the tabs on each side
that keep it latched to the Base Extrusion.
4
e. Turn the Right Sideplate over and position the
CoPilot Receiver (Item #2) on the inside of the
Right Sideplate so that the receiver mounting
holes are aligned with the Sideplate Mounting
Holes. Position the wires so that they pass to the
right of the CoPilot Receiver. This should consists
of a Foot Pedal Connection, a Power Connection
and an Antenna wire.
f. Using the two #8 x 5/8’’ screws
(Item #1)
provided, insert the screws through the receiver
and into the Right Sideplate. Be sure that the
wires are not pinched in the Sideplate Mounting
Holes when tightening the two screws. Do not
over tighten.
ITEM(S) NEEDED
#1 x 2
#2 x 1
CoPilot Receiver
CoPilot Receiver
CoPilot Receiver
Power Connection
Screws
Power Connection
Power Connection
Center Housing
Foot Pedal
Connection
Foot Pedal
Connection
Foot Pedal
Connection
Foot Pedal
Connection
Motor Cable Plug
Power Cable
Sideplate
Mounting Holes
Right Sideplate
Antenna
Antenna
Right Sideplate
Right Sideplate
Right Sideplate
Left
Sideplate
Power
Connection
5g
5i
4e
4f
Base
Extrusion