Minka 04728, Инструкция по эксплуатации Сертификат гарантии, Страница: 16 / 18

There is a "Universal Mode" and "Learning Mode" with the remote control.
When selecting "Universal Mode", simply place dip (code) switch to the UP
Position (COMMON CODE). There will be no need to pair your fan and
remote control.
Please Note: Under the universal mode setting, your fan can be controlled
by other transmitters also using the “Universal Mode” with no need to pair them.
To prevent any possible Interference with other fans in your home.
Minka recommends the use of the “Learning Mode” setting
by placing the dip (code) switch to the LOWER position (L. CODE) and follow
the steps below.
Learn Mode setting: Within 60 second of restoring power source to your fan, press
and hold the "LEARN" button for at least 3 seconds.
If the fan is installed with light, the light will blink 3 times.
This will indicate the process is complete and your fan is ready for use.
For fans without light, check operation using remote transmitter.
Note: Power must be off for a minimum of 10 seconds, before restoring power to attempt
the Learn Mode setting procedure.
Note:
If Multiple fans require to be controlled by a single remote transmitter Minka Recommends
Using the Learn Mode setting. Power to both fans will need to be restored at the same time and
Press the Learn button on the remote control so that both desired fans can receive the remotes
signal simultaneously.