Minimizer B4578BTPA, Инструкция по монтажу

Страница: 4 / 7

Revised 10/23/2017 Page 4
F. Some installations may not allow the center bracket to bolt through the ends of the
fenders.
a. In these cases use the plastic angle
(PB5071) to connect the fenders to the
center bracket assembly (Figure 8).
b.
Use three 5/16” x 1” bolts, washers, and
nuts to bolt PB5071 to the center bracket
assembly. Do not tighten these until the
fender assembly is level.
Recommended
torque is 10-15 ft-lbs.
Tip: PB5071 is also used as a height adjustment for the fender assembly.
G.
Drill four 5/16” holes through the fender using the holes in bracket PB5071
as a pattern (Figure 9).
a.
Install the 5/16” x 1 ¼” bolts through the bracket and into the
fender.
b.
Use 5/16” fender washers and 5/16” nuts provided with the kit on
the underside of the fender.
c.
Recommended torque for all 5/16” bolts is 10-15 ft-lbs.
H. If possible, position the mounting brackets so they
are located within 15” of the bottom of the fender.
This protects against wind blowing the leading edge
of the fender back into the tire (Figure 10).
Tip: If the front fender bracket is mounted
higher than 15”, refer to
http://www.minimizer.com/instructions%20.ht
ml
for further suggestions on adding
additional support.
Figure 10
Figure 8
Figure 9