MiniMax MM 16, Руководство пользователя

Страница: 6 / 34

5
needs to be reset to restart the saw. The Off button may need to be pulled out or
twisted
GENTLY to reset it, depending on the type of switch on your machine. It
is perfectly allright to test start the machine without a blade. If it does not start,
make sure the doors are closed and also be sure that there is no Cosmoline
gumming the safety microswitches.
DUST COLLECTION PORT SIZE AND AIR REQUIREMENTS
Dust Collection
Both the MM16 and MM20 have a 100mm(very close to 4”) extraction
port located on the mid right side of the saw See Figure 10 Dust Outlet. You may
connect a 4" flex hose directly or use a quick disconnect adaptor flange - 4" flex
hose to 100mm (available from Onieda Air Systems, see sources). Depending on
the particular hose or parts you get, it may be necessary to use a rubber
plumbing connector (4”) with two hose clamps to adapt your hose or the quick
disconnect to the outlet.
A replaceable plywood deflector below the lower guides helps direct
the dust to the port.See
Figure 11 Dust Deflector..
CFM Requirements)
For a 4” Flex tube, a conservative estimate is about 800 cfm on your
collection system to capture dust effectively. The actual figure can be estimated
by a Cyclone or dust collection supplier such as Oneida Air( See resources).It of
course depends on the distance from the collector and the pipe sizes and
geometry.
BLADE SELECTION/GUIDE ADJUSTMENT/MOUNTING
BLADES
Blade Selection
(BE CAREFUL, BLADES ARE SHARP!)