miniland 89237, Гарантийный талон и инструкция по эксплуатации

Страница: 13 / 48

13
5.2.5.2. SCAN MODE
This function enables you to see the paired camera channels in a rotational sequence, displaying the images of
each camera for 12 seconds.
This function can only be used when more than one camera has been paired. To use this mode:
1. Press the Menu / Back button (5) to access the menu.
2. Press the LEFT (9) or RIGHT (8) key until the select camera icon (H) is highlighted.
3. Press the UP (7) or DOWN (10) key until the SCAN mode icon appears and then press the confirmation key (11).
Note 1: If one of the cameras is out of range or not turned on, the monitor will notify you and the Scan mode
will turn itself off.
Note 2: There is a faster way of activating the SCAN mode if more than one camera is connected. Press the
select camera/ SCAN key (6) to see the cameras that have been paired in loop mode: CAM1 / CAM2 / CAM3 /
CAM4 / SCAN MODE.
5.3. TROUBLESHOOTING
ENGLISH
Problem Possible Cause Solution
No reception on the
monitor
Camera not turned on Press and hold down button (III) for 2
seconds
Monitor not turned on Press and hold down the Power button (12)
Camera: not plugged in to the
power adapter
Plug in the power adapter
Monitor: The power adapter is not
plugged
Plug in the power adapter
Monitor out or range Move the monitor closer to the camera
Connection lost between the
monitor and a camera already
linked
Link the camera with the monitor again.
See 5.2.3.
A wrong camera has been selected Change the camera number you are
watching. See 5.2.5.1.
Only black and white
images are displayed
Check whether the camera is in
night vision/infrared mode
In order to view the images in colour,
increase the level of light in the room the
camera is in or check there is nothing
covering the camera´s light sensor (II).
The camera does not
transmit
The camera is not turned on Press and hold down button (III) for 2
seconds
Camera: the power adapter is not
plugged in
Plug in the power adapter
VOX mode or Standby mode are
active
To see the monitored area continuously,
disconnect the VOX or Standby mode on
the Monitor
You cannot hear the baby
on the parent unit
The volume setting of the parent
unit is too low
Set the volumen to the highest level
Interference or poor
reception
Other electronic devices may be
interfering with the signal
Move them away from the device
The camera and monitor may be
too far apart
Move the monitor closer to the camera
The battery power may be too low Plug in the power adapter
The camera or monitor may be
placed too close to many metal
objects
Move them away from the device