miniland 89237, Гарантийный талон и инструкция по эксплуатации

Страница: 11 / 48

11
· Misuse of this Wireless Baby Monitor could result in legal action.
· Use this product responsibly.
IMPORTANT: Please note that any change or modification to the equipment not performed by the
Miniland technical service will not be covered by the product guarantee.
3.2. RADIO INTERFERENCE TIPS
This equipment has been subjected to tests and complies with the requirements of the RED Directive 2014/53/
EU. These requirements are designed to provide reasonable protection from harmful interference at residential
premises. If the unit is not installed and used in line with the instructions, this could cause harmful interference
to the radio communications.
However, bear in mind that it is not possible to ensure that interferences are not going to occur at a specific
installation. If the baby monitor causes interferences to radio or TV reception, which may be determined by
turning it off and on, the user is recommended to try and rectify the interference in the manner indicated below
· Reorient or change the position receiver.
· Increase the distance between the equipment in question and the baby monitor.
· Connect the equipment to a different socket from that used for the receiver.
· Consult the Customer Care department.
To ensure compliance with the RED Directive 2014/53/EU, this equipment has special shielded cables. Operating
with unapproved equipment or using unshielded cables will probably cause interference to radio or TV reception.
3.3. CHOOSING THE RIGHT PLACE
· Place the electronic device somewhere out of the reach of children so as to avoid accidents.
· The baby unit must be situated at least 1 and 1.5 meters away from the baby’s cot. Never place the baby unit
inside the cot, bed or playpen, nor secure the tripod to them. Make sure that the unit, the cables and the adapter
are well out of the reach of the baby and other young children.
· Put the baby monitor in a place where the air can circulate freely. Do not place it on duvets or soft blankets nor
in the corners of cupboards, shelves etc.
· Place the baby monitor well away from heat sources like radiators, chimneys, kitchens and direct sunlight.
· Keep the Camera away from TV appliances, repeaters and radios. The intense radio signals generated by
these elements could cause noise or even sounds or images to be broadcast on the monitor. Should this occur,
move the camera somewhere else.
4. CHARACTERISTICS AND FUNCTIONS OF THE PRODUCT
4.1. MONITOR FUNCTIONS AND CONTROLS (FIGURE A)
1. LED charge indicator
2. Link/ on LED
3. Volume LEDs
4. LCD screen
5. Menu / Back Button
6. Select camera mode / SCAN button
7. Nav UP / increase volume button
8. Nav RIGHT / increase brightness button
9. Nav LEFT / reduce brightness button
10. Nav DOWN (10) / reduce volume button
11. Confirmation / zoom button On / Off button
13. Talk to the baby button
14. Microphone
15. Speaker mode
16. DC power connector
17. Collapsible rack
18. Antenna
19. Manufacture code
a. Signal level
b. Camera selected
c. Monitor volume
d. Lullabies
e. Zoom
f. Night vision
g. Voice Mode
h. Temperature
i. Alarm icon activated
j. Battery level
k. Talk to the baby icon
A. Selection of lullabies
B. Alarm settings
C. Standby mode setting
D. Zoom
E. VOICE activation menu
F. Add camera menu
G. Remove camera menu
H. Select camera viewed / Standby mode
DISPLAY PANEL (FIGURE B)
Screen icons
Menu Icons
ENGLISH
I. Retractable antenna
II. Light sensor
III. On button
IV. Strap
V. Voice mode
VI. Pairing button
VII. Mini USB power connector
VIII. Microphone
IX. On / Pairing LED
X. Camera lens
XI. Infrared
XII. Tripod accessory
4.2. CAMERA FUNCTIONS AND CONTROLS (FIGURE C)