5.2.7. TRANSMISSION LEVEL
On this menu you can change the power level transmitted by the camera, choosing from
amongst the high/low options. When at the high position (HI), coverage will extend 300
metres in open country with the original power. When at the low position (LOW), the
maximum transmission distance is reduced to around 150 metres in open country as the
transmitting power is reduced.
To configure the transmission level, keep the zoom/menu button pressed and use the
buttons
▲
and
▼
to choose the transmission level icon and press the remote/accept
button to confirm. Using the buttons
▲
and
▼
again, choose whichever of the two camera
transmission levels available (HIGH/LOW) you prefer. Press the remote/accept button
again to confirm the selection.
5.2.8. ACCOMPANYING LIGHT
To activate the accompanying light, keep the zoom/menu button pressed and use the
buttons
▲
and
▼
to choose the night light icon and press the remote/accept button to
confirm. Using the buttons
▲
and
▼
again, choose whichever option - (ON) or (OFF) - you
prefer. Press the remote/accept button again to confirm the selection.
Bear in mind that the accompanying light will only be configured for the camera whose
image you are viewing on the monitor at that time.
5.2.9. PAIRING
This product is designed to allow the observation of different areas with up to 4 cameras
(channels 1, 2, 3 or 4 assigned to different cameras). The monitor and the original camera
leave the factory with channel 1 programmed. If you need to add an extra camera, follow
the process set out below.
Keep the baby talk button and the set button on the monitor
▲
pressed simultaneously until
the LED flashes. Then press the link button (V) of the camera. When you release the
camera button, the pairing process has finished and you should be able to clearly observe
the image captured by the camera on the monitor.
For various reasons you may lose the connection between the monitor and a camera which
is already connected. Should this be the case, repeat the process explained above to
connect the camera with the monitor again.
Problem
Possible Cause
Solution
There is no reception
on the monitor
The Camera has not come on
The Monitor has not come on
Camera: The AC adapter has
not been plugged in
Monitor: The AC adapter has not
been plugged in or the battery is
undercharged (check the LED
indicator)
Press and keep pressed in the
button (II) for 2 seconds
Press and keep pressed in the
on button
Plug in the AC adapter
Plug in the AC adapter or
charge the battery
5.3. FAULT LOCALIZATION
en
