Mini 2004 Mini Convertible Cooper, Руководство пользователя

Страница: 86 / 165

84
INTEGRATED UNIVERSAL REMOTE CONTROL
*
4. Simultaneously press the command but-
ton of the original control device and the
desired memory button 1 on the inte-
grated universal remote control. The
indicator lamp 2 begins to flash slowly.
Release both buttons when indicator
lamp 2 starts flashing rapidly. If indica-
tor lamp 2 does not start to flash rapidly
after approx. 15 seconds, change the dis-
tance between the two devices
5. Repeat steps 3 and 4 to program other
original control devices.
The corresponding memory button 1 is
now programmed with the signal of the
original control device.
The system can be operated as soon as the
ignition is switched on.
If the system cannot be operated
after repeated attempts at program-
ming, check whether the original control
device is equipped with an alternating-
code system. You can either check the oper-
ating instructions of the original control
device for this information, or you can
press and hold down the programmed
memory button 1 of the integrated univer-
sal remote control. If indicator lamp 2 of
the integrated universal remote control
flashes rapidly for a brief period and then
remains on for approx. two seconds, the
original control device is equipped with an
alternating-code system. In this case, the
memory buttons 1 are programmed as
described for an alternating-code control
device.
<
Alternating-code control device
You will need to refer to the operating
instructions of the system in question in
order to program the integrated universal
remote control. Read through the operat-
ing instructions for information on syn-
chronization.
Observe the following additional instruc-
tions when you program an alternating-
code control device:
You will find programming easier if
you have the assistance of a second
person.
<
1. Park your vehicle within range of the
radio-remote-controlled device
2. Program the integrated universal
remote control as described above in the
section on fixed-code programming
3. Locate the button on the receiver of the
target device, for example on the upper
part of the drive
4. Press the button on the receiver of the
target device. Once you have completed
step 4, you have approx. 30 seconds to
complete step 5
5. Press the programmed memory
button 1 of the integrated universal
remote control three times.
The corresponding memory button 1 is
now programmed with the signal of the
original control device.
Consult your MINI Dealer if you have
any questions.
<
Deleting memory buttons
It is not possible to delete individual mem-
ory buttons 1. To delete all three memory
buttons 1 at the same time, however, per-
form the following steps:
Press and hold both outer buttons 1 of the
integrated universal remote control for
approx. 20 seconds until indicator lamp 2
flashes.
Online Edition for Part-No. 01 41 0 158 427 - © 07/04 BMW AG