Minelab GP 3000, Инструкция по эксплуатации

Страница: 13 / 63

Attaching the handle and bungy cord
Figure 2.4, refer also Figure 2.2
STEP 1
Slide the handle (9) onto the end of the upper shaft (8) and set it
to a comfortable position. Tighten the two screws in the base of
the handle with a small flat tipped screwdriver to hold the handle
in position.
STEP 2
Slide the bungy cord knuckle (22) of the bungy cord onto the
upper shaft (8).
Assembling the intermediate and upper shaft sections
Figure 2.5, refer also Figure 2.2
STEP 1
Slide the intermediate shaft (7) into the end of the upper shaft
(8) and snap into place.
STEP 2
Check that the coil (1) has a skid plate (3) attached.
STEP 3
Check that the coil pivot end of the lower fibreglass shaft (4) has
two teardrop washers (5) installed.
N NOTE The washers should always be full thickness
and should be replaced regularly as they wear out and
allow the coil to become loose.
STEP 4
Push the lower fibreglass shaft (4) into the mounting brackets on
the coil and ensure that the spring clip at the rear of the
fibreglass shaft faces the rear of the coil.
Attaching the coil
Figure 2.5
STEP 1
Line up the holes in the coil with the pivot end of the
fibreglass shaft (4).
STEP 2
Push the nylon bolt through the holes and fit the nylon wing nut
then tighten by hand.
NOTE Do not over tighten the nut as the coil housing
may be crushed or damaged.
COMPLETE ASSEMBLY INSTRUCTIONS
Figure 2.4 Handle and bungy cord
Figure 2.5 The coil pivot end of the lower
fibreglass shaft
9
ASSEMBL
Y
2
Handle with
Wrist Strap (9)
Bungy Cord (21)
Bungy Knuckle (22)
P0512-A
11” Double D Coil (1)
& Skid Plate (3)
Tear-drop Washers (5)
Nylon Nut & Bolt (6)
P0513-B