Page 10
The Minelab Excalibur Family
d) Push the black nylon bolt (11) through the holes in the bracket on the
coil from the cable entry side, then place the wing-nut on the other end
of the bolt and tighten it by hand.
Figure 3 - Excalibur with shaft assembled for Wader’s Mode
Diver’s Mode
Before setting up the detector for Diver’s Mode you will need to obtain the
short fiberglass tube, which can be purchased as an accessory.
a)
Remove the tape on the short fiberglass tube (13) that is holding the black
teardrop washers (10) in place.
NOTE:
Make sure that the washers do not fall out after removing the tape.
b)
Remove the black nylon nut, washer, and bolt (11) from the coil (12).
c)
With the teardrop washers in place, push the lower tube assembly into the
bracket on the coil so that the holes line up.
NOTE:
Ensure that the spring clip near the top of the fiberglass tube is pointing
toward the rear of the coil.
