Minebea CSD-912B, Инструкция по эксплуатации, Страница: 57 / 366

4.4.Adjustment after calibration
39
4
Calibration
3. Enter the mass of the weight.
POINT
- Refer to “3.5. Input of numerical values”
for more information about how to enter
numerical values.
4. Tap [OK].
The compensation point 1 has been corrected, and
Digital linearization screen will be displayed.
5. Repeat the steps1. to 4. to perform
corrections for the compensation point 2 and3.
POINT
- Set [LINEARISE COMPENSATION 2]
and [LINEARISE COMPENSATION 3]
for the compensation points 2 and 3
respectively.
- To delete compensation values, tap
[LINEARISE CLEAR], [VALID], and [OK]
in sequence. This will delete the
compensation values of all the points.
3LWFKFRQ¿UPDWLRQUHJLVWUDWLRQ
After zero adjustment, place an arbitrary load on the weighing device and register the output
A/D count value as a pitch point. You can register up to six pitch points.
Though you normally need to verify measuring performance by placing loads in stages up to
the span point after calibration, use of [PITCH CONFIRMATION SET] allows you to
FRPSOHWHFDOLEUDWLRQDQGYHUL¿FDWLRQDWWKHVDPHWLPH>3,7&+&21),50$7,216(7@LV
useful if the mass of the measured object is large.
POINT
- [PITCH CONFIRMATION SET] should be done after [ZERO ADJUSTMENT]
and before [SPAN ADJUSTMENT].
(1) Pitch registration
Place an arbitrary load on the weighing device and register the output A/D count value as a
pitch point. As for the last pitch point, place a load equal to that of the span point to register it
as the span point.