Minebea CSA-521, Инструкция по эксплуатации

Страница: 7 / 32

V
2. Power supply

Warning
●
Be sure to check that the power supply is off in connecting each cable. If the work is
done while the power is on, there may have the case that electric shock to the operator
or even may have damage to the instrument.

Warning
●
Before supplying the power, check that the indication of power supply voltage
/specifications
for the instrument and the power going to supply should be the same.
If they are not equal, contact
us
.
If you use the instrument without checking them, it may cause a damage in the
instrument or electric shock to the operator.

●
Earth wire should be grounded securely.
When earth wire is not connected, it may cause a malfunction of the instrument or
electric shock to the operator.
3. Application note

Warning
●
Before using a new instrument or exchanging the strain gage applied transducer for a
new one, be sure to make calibration. If calibration will not be made, the correct
measuring results may not be obtained nor which may cause malfunction in the
instrument and there may exist damage in peripheral equipments.
Besides, even though calibration has been made, there may occur the similar case when
the results are not correct, so make calibration, again.

Warning
●
In case of using the instrument, check that the connections are executed properly. If not
connected properly, the correct measuring result will not be obtained, nor it may cause
malfunctions of the instrument, damage to the peripheral equipments or even more
serious accidents.

Warning
●
When change of setting is made carelessly on the instrument during measurement,
correct measured results may not be obtained and it may cause malfunction in the
instrument and even have the possibility of damage in peripheral instruments.

Warning
●
Do not shock the instrument such as throwing something on it.
If neglected, it may cause destruction of the parts and damage to the electrical circuits.