Minebea Intec PR 5110, Инструкция по эксплуатации инструмента

Страница: 19 / 36

4.3 Table-top devices
4.3.1 Cable gland
The cable wires are connected to the terminals inside the device.
NOTICE
Property damage is possible.
Regularly check the itted cable gland for tightness and re-tighten it, if necessary.
4.3.2 Installation of a cable with screw
NOTICE
Material damage is possible.
Do not guide the screen (4) into the device!
With cables lengths >50 m, the cable screen must not be connected.
The cable shield (4) must be connected in the metal sleeve (6) of the cable gland.
Before, during and after installation, make sure that the sealing ring is seated
correctly.
4. Cut back the cable screen (3) up to 5 mm and bend back over the cable mantel (1).
5. Remove the insulation of the cable strands 3 mm and solder.
6. Insert pin housing.
7. Lay cable under the cable clamp (2).
Grounding tab (4) presses on the surrounding cable screen (3) and the cable
clamp (2) presses on the cable mantel (1).
8. Close and tighten the cable clamp (2).
9. Check the strain relief.
10. Insert the mounting screws on both sides.
11. Close the plug housing (stop clamps).
1. Unscrew the sleeve screw cap (1).
2. Slide the cap (1) and plastic cone (3) onto the cable (2).
4 Device installation Remote display PR 5110/60, ../70
EN-17 Minebea Intec