Minebea Intec PR 1626/60, Инструкция по эксплуатации инструмента

Страница: 8 / 24

For installation and connection refer to chapter 5 , to the application information of this
manual, and observe the required environmental conditions as stated in the technical
data, chapter
8 .
Note:
The PR 1626/60, ../61 terminal must be connected to the potential equalization
system.
2.5 Repairs and maintenance
2.5.1 General information
Repairs are subject to inspection and must be carried out at Minebea Intec.
In case of defect or malfunction, please contact your local Minebea Intec dealer or service
center for repair.
When returning the device for repair, please include a precise and complete description of
the problem.
Maintenance work may only be carried out by a trained technician with expert knowledge
of the hazards involved and the required precautions.
National laws and directives must be observed, in particular EN 60079-14/-17/-25.
2.5.2 Failure and excessive stress
If there is any reason to assume that safe operation of the device is no longer ensured,
shut it down and make sure it cannot be used.
Safe operation is no longer ensured if any of the following is true:
- The device is physically damaged.
- The device does not function.
- The device has been subjected to stresses beyond the tolerance limits (e.g., during
storage or transport).
2.5.3 Electrostatically sensitive parts
This device contains electro-statically sensitive components. Therefore, potential
equalization must be provided when working on the device (antistatic protection).
2.5.4 Replacing fuses
The replacement of fuses is not permitted!
Intrinsically safe load Cell interfaces PR 1626/60, ../61 2 Safety instructions
EN-6 Minebea Intec