8
3.
A ¾” hole must be drilled into the surround panel and through the substrate in order to
use the MAW35-SD Master WingIt. These holes need to be drilled precisely in order to
maintain alignment of the top of the foot rest ledge
with the 1½” solid band.
4. Install the WingIt Model # MAW 35-SD as per instructions which accompany the WingIts
package, being sure to leave approximately 1” of the Truss Head on the screw sticking
out. See illustration (3). Please Note: The screws will be tightened after the foot rest
ledge has been put onto the wall
ILLUSTRATION 3:
5. Apply 100% silicone to the entire back of the foot rest ledge
, using a minimum ¼” bead
of silicone.
This step cannot be skipped or avoided, as the silicone adhesive is a
necessary product in the installation of the foot rest ledge as the truss head
screws are not designed to be a stand alone installation product.
6. Slide the foot rest ledge over the Truss Head Screws and press firmly into place. See
drawing (B). Be sure to clean up any silicone that is smeared onto the wall during this
process, as soon as you have secured the foot rest ledge in place. A clean dry rag
should be all that is needed, but acetone or mineral spirits can be used on a rag to clean
up excess silicone.
Drawing B:
