5
6. Using a # 2 Phillips head screwdriver, tighten the truss head screws as tightly as
possible. You will hear creaking noises when the screw is tight against the support of the
foot rest ledge.
A right-angle screwdriver will make it easier to turn the screws. A
ratcheting right-angle screw driver is optimal for this installation
.
7. Once the truss head screws have been tightened, try to move the foot rest ledge by
applying pressure with your hands to the foot rest ledge. If there is any movement, re-
tighten the screws until movement stops.
8. Apply color matching silicone around the perimeter of the foot rest ledge to seal the foot
rest ledge to the cast marble panels. This seal should go around the entire perimeter of
the foot rest ledge, even under the bottom of the foot rest ledge.
DISCLAIMER NOTICE: If the prescribed method of installation is not followed
precisely, the foot rest ledge may detach from the wall and cause damage to the
panels and the walls. If the foot rest ledge detaches, physical injury to the
occupant of the shower may occur. Mincey Marble will not be liable for any
damages to persons or property because of incorrect installation.
For complete information on installing the foot rest ledge into an area which
DOES NOT
have wood blocking, please see Section II.
The completed installation of the panel system shower pan and foot rest ledge should
look like the following:
If you have any questions, please call Mincey Marble Customer Service at 800.533.1806
