MIMAKI OPT-J0536, Руководство по эксплуатации

Страница: 7 / 18

7
Use the heater
Turn on the heater
1
Switch the voltage selector switch to the voltage
value to be used.
2
Check the power cable is plugged into the heater
dedicated inlet to the UCJV300.
• In the foreground is the inlet for the heater (INLET2).
3
Turn heater power switch ON.
• In the foreground is the power switch for the heater. Turn it to the "I" side.
Setting the Heater Temperature
Set the heater temperature according to the media you are using.
1
Press the [ENTER] key to cancel the message dis-
play.
• The Heater Temperature Setup screen appears.
• PRE (Pre-heater): Preheats the media before printing to suppress rapid temperature change.
• PRINT (Print heater): Helps prevent ink bleeding.
• The factory default setting is "220".
• Use only the accessory power cable.
• Connect the power cable to a power outlet near the unit so that
it can be easily routed.
• Connect the plug of the power cable to an outlet with grounding
polarity. Failure to do so may result in a malfunction of the unit,
electric shock, or fire.
• The temperature can be changed even during printing.
• Depending on the ambient temperature, it may take several minutes to several tens of minutes to reach the set heater tem-
perature.
• This printer should be used in an ambient temperature of 20°C~30°C. Depending on the operating environment and printing
conditions, the heater temperature may not rise to the set value.
• In the factory default setting, the heater setting temperature is
displayed as "- - -" and the heater is turned off.
• If [HEATER] is not displayed, press the [SEL] key to switch the
function.
REMOTE MENU
TEST PRINT
CLEANING
30
° /
40
°
DATA CLEAR ADJUST HEATER
PRE PRINT
40
° /
40
°
40
° /
40
°
Local <Setup 1>