MIMAKI JV33-130BS, Руководство по эксплуатации

Страница: 64 / 206

3-8
Changing the set value of Heater
Rough guide for temperature setting
Changing temperature settings of Heater
Set each item of [SET TEMP] and [SET TIME] .
1
Press the key in the local
mode.
2
Press the key.
3
Select the type (1-4) by pressing the
key.
Type of media PVC Tarpaulin FF
Pre-heater 35°C 35°C 35°C
Print-heater 35°C 35°C 35°C
Post-heater 50°C 50°C 50°C
• Adjust each heater temperature to a value best suited to the media conditions.
SET TEMP
Change the set temperature of the Pre-heater, Print-heater and
Post-heater built in the platen.
SET TIME
STANDBY
Set the period of time from when printing is completed to when the
heater temperature begins to drop to the preheat temperature.
Set value : NONE, 0 ~ 90min (10min unit)
• The preheat temperature is preset and cannot be changed.
• If the machine receives data at the preheat temperature, the heaters
automatically raise their temperatures up to the preset levels and
then the machine starts printing.
• When [
NONE] is selected, the temperatures do not drop to the
preheat level.
OFF TIME
The heaters are turned off in the following case:
• If a preset time has passed without printing while the machine is in
standby mode.
• With STANDBY- [
NONE] selected, when preset time passes without
printing after some printing.
Set value : NONE, 0 ~ 90min (10min unit)
If the machine receives data with the heaters turned off, the heaters
are automatically turned on to raise their temperatures up to the
preset levels and then the machine starts printing.
• With [
NONE] selected, the heaters are not turned off.
• It turns "OFF" at end of printing if "0min" is set.
F UNC T I ON
S E T UP
< EN T >
S E T UP
S E L EC T
: T Y P E . 1