MIMAKI JV300-130 A, Руководство по установке

Страница: 14 / 60

© 2014 MIMAKI ENGINEERING CO.,LTD. 4.2 P.7
4.2 Assembling the Stands and the Device
R.1.0
1
2
3
4
5
6
7
14. Put the front face of the stand first.
Align the screw hole of the stand and that of the main unit.
15. Fix the main unit and legs with the 8 screws (M5x15).
Use the provided hexagonal wrench.
If the screw holes of the main unit and of the stand do not fit,
follow the steps below.
1. Loosen the 4 screws (M5x15) of the upper stand stay on the
back of the main unit, turning one-half with the supplied
hexagonal wrench.
2. Fitting the screw holes of the main unit and the stand,
temporarily tighten the 8 screws (M5x15).
3. Fully tighten the screws that were loosened on the step (1).
4. Fully tighten the screws that were temporarily tightened on the
step (2).
 Be sure to turn “one-half” to loosen the screw.
 Do not loosen the screw of the lower stand stay
on the front of the main unit.
 Hold down the stand stay and tighten the screw.
Leg stay
INSTALLATION GUIDE > Printer Assembly > Assembling the Stands and the Device
Model JV300
Issue 2014.04.11 Revised
F/W ver. 1.00 Remark
1.0
Rev.