MIMAKI Electric slicers, Руководство по уходу

Страница: 5 / 8

5
6. How to recover improper nozzle flashing
When not using this plotter for a long time or according to environmental temperature, nozzle flashing may
become unstable. In this case, follow the procedure below to recover nozzle.
1) Daily care
Execute daily care all parts noted on this manual.
2) Normal cleaning
( Operation manual Chapter2 “Checking and solving nozzle clogging”)
Execute normal cleaning along the operation manual after executed daily care.
Repeat cleaning and test printing, then confirm the nozzle clogging resolved.
3) Hard cleaning
( Operation manual Chapter2 “Checking and solving nozzle clogging”)
If nozzle clogging cannot be solved even executed normal cleaning several times, change the cleaning
mode to hard cleaning, and execute the same procedures.
4) Nozzle cleaning
( Operation manual Chapter3 “Cleaning the nozzle [NOZZLE WASH]”)
In case nozzle clogging or other problems can not be cleared away after all these procedures, execute
nozzle cleaning.
The execute cleaning and test printing for one minute
5) Nozzle cleaning
( Operation manual Chapter3 “Cleaning the nozzle [NOZZLE WASH]”)
In case nozzle clogging is not solved with nozzle cleaning above-mentioned, set the TIME to leave 5 min-
utes, and execute nozzle cleaning and test printing again.
In case nozzle clogging is not resolved with all these procedures, contact with our customer service or make
service call to the agency you purchased.
7. Supplies
• Cleaning wiper kit (SPA-0116)
• Cleaning fluid RS (SPC-0336)
• MS2 kit (SPC-0369)
• Y main shaft oil (SPC-0364)