OPERATION:
•
Connect the supplied 12 VDC
power adapter to the meter
and to the mains.
•
Connect the ORP electrode
to the BNC socket on the
bottom of the meter.
•
Always remove the electrode
protective cap before taking
any measurement. If the elec-
trode has been left dry, soak
the tip (bottom 2.5 cm) in
rinse solution (M10000B) for
a few minutes to reactivate it.
•
Turn the instrument on by
pressing the ON/OFF key.
•
Allow the reading to stabilize
and the meter will start con-
tinuous monitoring.
•
The meter is factory calibrated.
•
A blinking alarm will indicate when the measured ORP
value is lower than the setpoint.
NOTE:
• The power contact is not protected by fuse inside the
meter. It is recommended to protect it outside, against
failure.
• WARNING: when the alarm led is blinking, the mains
voltage is present in the output power socket.
SETPOINT:
• The setpoint can be selected
by adjusting the central front
knob to the desired value.
• The selectable range for
SMS510 is from 0 to 600 mV.
INSTALLATION PROCEDURE:
