Milwaukee M18 HCC75R, Оригинальное руководство пользователя

Страница: 13 / 153

Deutsch
11
GB
English
4. Pull the trigger (1) and slide the trigger lock to (2).
Ö
The tool‘s remote cut light will be flashing red.
1
2
5.
Turn ON (I) the remote.
Ö Light 1 will be steady blue.
Ö Light 2 will be flashing red.
Note:Light 1 flashing blue and Light 2 off indicates the remote
is out of range of the tool. Move the remote closer to the tool.
6.
Press and hold button 2 for 2 seconds.
Ö Light 2 will be steady red.
Ö Light 3 will be flashing red.
2 sec
7.
Within 20 seconds, press and hold button 3 for 2
seconds to begin the cut.
Ö Light 3 will be steady red.
Release button 3, cutting will begin.
Note, if more than 20 seconds passes between step 4 and 5,
reset (see step 7) and begin again.
2 sec
5.
8.
When the cut is complete, the cut indicator will light:
Ö Green = Maximum cutting force achieved
Ö Red = Cut Failed
9.
To reset, pull the trigger (1) to unlock.
Pull the release trigger (2) to reset the jaws.
Turn OFF (0) the remote cut switch (3).
1
2
3
ACTION IN THE EVENT OF FAULTS
• The cable can be broached and become live, always inform the
network operator, stop the cutting process, and initiate suitable
protective measures
• Always ensure that the device is and will stay disconnected from
the power supply before approached and touching the device
• press and hold the reset button until the cutter opens completely
• check the battery capacity
• check the material and material thickness against the technical
data
• If it is suspected that a live cable has been cut, the cable-cutter
has to be inspected in an authorized specialist workshop
JAMMED BLADES
Dirt and debris can cause the blades to become jammed together
after a cut
• Press and hold the release trigger to ensure the tool has reset.
• Remove the battery pack.
• While holding in the release trigger, use a rubber mallet to tap
the blade retainer until the blades open.
• Clean any dirt and debris from the blades before starting another
cut.