5
WARNING
To reduce the risk of personal in
-
jury, always hold tool securely.
Starting, Stopping and Controlling Speed
1.
2.
OPERATION
WARNING
To reduce the risk
wear proper eye protection marked
of injury, always
to comply with AS/NZS 1337.1.
Trigger Lock
To
lock
the trigger, push the trigger lock to the right.
The trigger will not work while the switch is in the
locked position. Always lock the trigger and remove
the battery pack before performing maintenance and
changing accessories. Lock the trigger when storing
the tool and when the tool is not in use.
To
unlock
the trigger, push the trigger lock to
the left.
To
start
the trigger.
To
vary
the speed, increase or decrease the pres-
sure on the trigger. The further the trigger is pulled,
the greater the speed.
WARNING
To reduce the risk of explosion,
3. To
stop
the tool, release the trigger. Make sure the
blade comes to a complete stop before removing
the blade from a partial cut or laying the tool down.
Electric Brake
General Cutting
Cutting Metals
Begin cutting at a slow speed, gradually increasing
speed during the cut. When cutting into metals or
hard materials that can not be cut from an edge, drill
a starting hole larger than the widest part of the blade.
electric shock and property dam-
age, always check the work area for hidden gas
pipes, electrical wires or water pipes when mak-
ing blind or plunge cuts.
Plunge Cutting
A
B
NOTE:
To make plunge cutting easier, use a heavy
gauge blade and install the blade with the teeth facing
upward as shown in Column B.
1. Insert the blade into the tool.
If blade is inserted with the teeth facing downward,
hold the tool as shown in Column A, resting the
edge of the shoe on the workpiece.
If blade is inserted with the teeth facing upward,
hold the tool as shown in Column B, resting the
edge of the shoe on the workpiece.
2. With the blade just above the workpiece, pull the
trigger. Using the edge of the shoe as a pivot, lower
the blade into the workpiece as shown.
3. As the blade starts cutting, raise the handle of
the tool slowly until the shoe rests firmly on the
workpiece. Then guide the tool along the cutting
line to acquire the desired cut.
The electric brake engages when the trigger is
released, causing the blade to stop. Generally, the
saw blade stops within two seconds. However,
there may be a delay between the time the trigger
is released and when the brake engages.
Occasionally the brake may miss completely. If the
brake misses frequently, the saw needs servicing
by an authorised
MILWAUKEE
®
service facility.
Always wait for the blade to stop completely before
removing the saw from the workpiece.
For straight or contour cutting from an edge, line
the blade up with the cutting line. Before the blade
contacts the workpiece, grasp the handle firmly and
pull the trigger. Then guide the tool along the cutting
line. Always hold the shoe flat against the
workpiece to avoid excessive vibration.
When working in dusty situations, wear
appropriate respiratory protection.
Always remove battery pack before changing or
removing accessories. Only use accessories
specifically recommended for this tool. Others
may be hazardous.
NOTE:
A LED is turned on when the trigger is
pulled.
MILWAUKEE
®
Sawzall
™
reciprocating saw is ideal
for plunge cutting directly into surfaces that can not
be cut from an edge, such as walls or floors. Plunge
cutting may be done two ways depending on how
the blade is inserted. Column A shows how to plunge
cut with the teeth of the blade facing downward.
Column B shows how to plunge cut with the teeth of
the blade facing upward. Do not plunge cut into
metal surfaces (see "Cutting Metals".)
Содержание M18 FUEL SAWZALL CSX2
Страница 7: ......
