![background image](http://html1.mh-extra.com/html/milwaukee/m18-fuel-fmdp/m18-fuel-fmdp_operators-manual_1798265004.webp)
4
ASSEMBLY
WARNING
Recharge only with the charger
-
manual supplied with your charger and battery.
Removing/Inserting the Battery
To
remove
the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
Always remove battery pack before
changing or removing accessories.
To
insert
the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
recommended for this tool. Others
may be hazardous.
Attaching Feed Handle
1. Line up the anvil and slide the handle into place
on the desired side of the tool.
2. To remove, press the centre button and pull the
handle away from the tool.
Do not use a wrench, pipe, or any other lever in place
of the feed handle.
Motor adjustment lever
The motor adjustment lever is used to raise and lower
the motor on the slide rail. Always hold the motor
securely before loosening the adjustment lever.
Installing the Cutting Fluid Bottle
1. Ensure
2. Fill the bottle with HAWG WASH
®
3. Attach the bottle bracket to the drill.
4. Attach
OPERATION
WARNING
Always remove battery pack before
changing or removing accesso-
-
mended for this tool. Others may be hazardous.
To reduce the risk of injury, always wear safety
goggles or glasses with side shields.
Typical Operation
1. Check the work surface to make sure it is clean
and free of foreign materials.
Paint, rust, scale or uneven surfaces decrease the
holding strength of the magnet. Chips, burrs, dirt
and other foreign materials on the surface of the
magnetic base will also decrease holding power.
and free of nicks.
2. To install/remove cutter:
A. Remove battery pack.
B. Raise the drill motor to its highest position on
the slide rail.
C. Twist the quick-change arbor. Insert the cutter
into the arbor and release collar. Tug on cutter
to ensure it is secure. Cutter should be fully
seated into spindle.
D. Reverse procedure to remove cutter.
FUNCTIONAL DESCRIPTION
1. Slide rail
2. Carrying handle
3. Feed handle
4. Battery bay
5. Magnet activation knob
6. Speed selector
7. Motor adjustment lever
8.
9.
10.
11. ON(I) / OFF(O) switch
12. Drill motor
13.
14. Quick-change arbor
15. Safety strap bracket
(strap not shown)
16. Magnetic base
17. LED button
1
3
2
4
5
6
7
13
12
8
10
9
11
14
16
15
17
The drill attaches magnetically to 6mm (1/4") or
thicker ferrous stock. Do not use on stock less
than 6mm (1/4"). The magnetic base WILL NOT
hold on nonmagnetic grades of stainless steel.
Содержание M18 FUEL FMDP
Страница 7: ......