Milwaukee HD18 AG125, Руководство оператора

Страница: 6 / 11

6
funcTional descripTion
assembly
Warning
Recharge only with the
charger specified for the battery. For specific
charging instructions, read the operator’s
manual supplied with your charger and battery.
Inserting/Removing the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
To insert the battery, slide the pack into the body of
the tool. Make sure it latches securely into place.
Installing Side Handle
The side handle may be installed on either side
or the top of gear case. Position side handle in
the location which offers best control and guard
protection. To install, thread side handle into side
handle socket and tighten securely.
Installing, Removing and Adjusting the Guard
This tool is shipped with a guard. A guard must be
used when using the tool as a grinder. The guard
may be removed when using tool as a sander.
1. To remove the guard, remove the battery pack
and remove any accessories from spindle.
2. Press in the lock lever and rotate the guard to
line up the tabs on the grinder with the slots in
the guard.
3. Press in the lock lever and lift the guard straight
up and away from the tool.
4. To install the guard, remove the battery pack
and remove any accessories from the spindle.
5. Line up the tabs on the grinder with the slots in
the guard.
6. Press in the lock lever and press the guard onto
the tool.
7. To adjust the guard, press in the lock lever and
rotate the guard to one of five detent slots.
Warning
To reduce the risk of injury
when grinding:
• ALWAYS use the proper guard.
• ALWAYS properly install the guard.
• ALWAYS hold the tool firmly with both
hands using the handles provided before
and during grinding.
• NEVER use a wheel that has been dropped.
• NEVER bang grinding disc onto work.
• NEVER grind without proper safety
equipment.
Tab
slots
Fig. 1
Detent
slots
Warning
Always remove battery
pack before changing or removing accesso-
ries. Only use accessories specifically recom-
mended for this tool. Others may be hazardous.
Warning
Only use accessories with
Maximum Safe Operating Speed rated at least
equal to the maximum speed marked on the
power tool. This speed is based on the strength
of the wheel, allowing for a reasonable mea-
sure of safety. It is not meant to imply a best or
most efficient operating speed. Do not exceed
the Maximum Safe Operating Speed.
Cat. No. Volts
DC
No Load
RPM
Spindle
e zi S d a e r h T
Wheel Thickness
Size
HD18 AG125
18 125mm (5")
SYMBOLOGY
SPECIFICATIONS
Volts
Direct Current
No Load Revolutions per
Minute (RPM)
M14 10 000
FUNCTIONAL DESCRIPTION
1. Side handle
2. Spindle lock
3. Side handle sockets
4. Paddle switch
1
4
5 6
7
3
2
5. Switch lock-off
6. Guard
7. Guard lock lever
Regulatory Compliance mark
(RCM). This product meets
applicable regulatory
requirements.