9
OPERATION
Starting and Stopping and Controlling
Speed
1.
Pull trigger to dispense caulk.
2.
Increase or decrease pressure on trig-
ger to adjust the speed for proper bead
width and material feed rate. Material
type, temperature and nozzle diameter
will all affect flow rate. When using a
tube or pack with a smaller nozzle di-
ameter use a slower speed or the
material may be forced around the rear
tube seat.
3.
Release trigger to stop dispensing
caulk.
Locking the Trigger (Fig. 6)
Always lock trigger or remove battery pack
before changing accessories or perform-
ing maintenance. Lock trigger when the
tool is not in use and when storing the tool.
1.
To
lock
the trigger, push trigger lock
in the direction shown. The trigger will
not work when the trigger lock in the
locked position.
2.
To
unlock
the trigger, push the trigger
lock in the direction shown.
WARNING!
When tool is not in use, lock trig-
ger to prevent the tool from be-
ing accidentally turned on.
Fig. 6
Locked
Unlocked
Installing Sausage Type Pack
Always check sausage packs for punc-
tures or damage to the pack before install-
ing. Do not use a damaged or frozen pack.
1.
Lock trigger or remove battery pack.
2.
Press in and hold rod release trigger.
3.
Grasp plunger rod handle and pull
plunger rod back to allow sausage
pack to fit inside barrel tube.
4.
Insert pack into barrel tube.
5.
Cut off end of sausage pack.
NOTE:
Before using a partially filled
pack, remove any hardened material.
6.
Insert nozzle supplied with the sau-
sage pack into the nozzle cap (coarse
thread). Thread nozzle cap onto the
front of barrel tube.
7.
Cut nozzle at an angle and size per
manufacturer's recommendation to suit
the job. A smaller nozzle diameter re-
quires more force to push the caulk
and reduces battery life.
8.
Press in and hold rod release trigger.
9.
Push plunger rod handle forward until
plunger is against sausage pack.
10. Release rod release trigger.
