![background image](http://html1.mh-extra.com/html/milwaukee/4555-22/4555-22_operators-manual_1799435018.webp)
page 18
GENERAL MAINTENANCE
NOTE: The Honda GX390 engine has a separate warranty
found in the engine manual (included with this product).
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
Only the parts shown on the parts list are intended to
be repaired or replaced by the customer. All other parts
should be replaced at an authorized service center.
When servicing, use only identical replacement
parts. Use of any other parts may create a hazard
or cause product changes.
WARNING
To reduce the risk of injury, always shut off engine
and relieve system pressure before performing any
maintenance. Never disassemble the machine.
WARNING
Never let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken
or destroy plastic which may result in serious per-
sonal injury.
WARNING
Before running the engine, perform the following pre-
operation steps:
1. Check that all bolts, nuts, etc., are securely tight-
ened.
2. �Make sure the air filter is clean (see separate engine
manual).
3. �Check both the engine oil level and the fuel tank level;
refill as needed.
4. �Inspect the work area for hazards.
5. �If there is excessive noise or vibration, stop the unit
immediately.
NOZZLE MAINTENANCE
See Figure 20.
Excessive pump pressure (a pulsing sensation felt while
squeezing the trigger) may be the result of a clogged or
dirty nozzle.
1.
�Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
2.
�Remove the nozzle from the spray wand.
NOTE: Never point the spray wand at your face.
3.
�Using the nozzle cleaning tool provided, free any for-
eign materials clogging or restricting the nozzle.
4.
�Using a garden hose, flush debris out of nozzle by
back flushing (running the water through the nozzle
backwards or from the outside to the inside).
5.
�Reconnect the nozzle to the spray wand.
6.
�Turn on the water supply and start the engine.
NOZZLE
CLEANING TOOL
NOZZLE
Fig. 20
MAINTENANCE
Содержание 4555-22
Страница 74: ...p gina 74 NOTAS...
Страница 75: ...p gina 75 NOTAS...