10
To reduce the risk of injury,
always wear eye protection.
WARNING!
Using Forward/Reverse Switch (Fig. 10)
1.
For
forward
(clockwise) rotation, push
the forward/reverse switch to
FWD
as
shown.
2.
For
reverse
(counterclockwise) rota-
tion, push the forward/reverse switch
to
REV
as shown. Although an inter-
lock prevents reversing the tool while
the motor is running, allow it to come to
a full stop before reversing.
Locking Trigger (Fig. 11)
The lock button holds the trigger in the ON
position for continuous full speed use.
To reduce the risk of injury, keep
hands and cord away from the bit
and all moving parts.
WARNING!
OPERATION
Forward
Fig. 10
Trigger
Reverse
Lock
button
Fig. 11
Drilling
1.
Before drilling, be sure the workpiece
is clamped securely. Use backing ma-
terial to prevent damage to the work-
piece during breakthrough.
2.
When starting a hole, place the drill bit
on the work surface and apply firm
pressure. Begin drilling at a slow speed,
gradually increasing the speed as you
drill.
3.
Always apply pressure in line with the
bit. Use enough pressure to keep the
drill biting, but do not push hard enough
to stall the motor.
4.
Reduce pressure and ease the bit
through the last part of the hole. While
the tool is still running, pull the bit out of
the hole to prevent jamming.
Stalling
If the tool seems as if it is about to stall,
maintain a firm grip and reduce pressure
slightly to allow the bit to regain speed. If
the tool does stall, release the trigger im-
mediately. Reverse the motor, remove the
bit from the work and start again. Do not
pull the trigger on and off in an attempt to
start a stalled drill. This can damage the
drill.
Starting, Stopping and Controlling
Speed
1.
To
start
the tool, pull the trigger.
2.
To
stop
the tool, release the trigger.
3.
To vary the drilling speed, simply in-
crease or decrease pressure on the
trigger. The further the trigger is pulled,
the greater the speed.
To reduce the risk of explosion,
electric shock and property
damage, always check the work
area for hidden pipes and wires
before drilling.
WARNING!
1.
To
lock
the trigger, hold the lock button
in while pulling the trigger. Release the
trigger.
2.
To
unlock
the trigger, pull the trigger
and release. The lock button will pop
out.