Milton Roy MILROYAL D, Инструкция по эксплуатации

Страница: 10 / 32

6
Instruction Manual
The MILROYAL
®
D Pump has been carefully
designed, manufactured, assembled, and tested
to give reliable service with a minimum amount
of maintenance. However, in normal operation,
a periodic check of the pump is recommended to
visually confirm proper operation of the pump.
3.1 LUBRICATION
Fill the gear section of the MILROYAL
®
D housing
with recommended gear lubricant (see page 8 for
oil type)
to the oil level plug hole. The oil should be
changed every 2500 hours of operation or every
six months, whichever comes first. This can often
be scheduled with winter and summer oil change.
3.2 SPARE PARTS (Figure 3)
It is recommended that a standard group of spare
parts
(shown in Table 4)
be kept on hand at all times
to prevent serious delays in repairs. The following
list of spare parts represents those which should
be kept on hand for each pump drive (see liquid
end section for spare parts for liquid end).
Parts orders must include the following information:
1. Quantity required.*
2. Part number.*
3. Part description.*
4. Pump serial number (include in all
correspondence regarding the pump).**
5. Full model number.**
* Found in this manual.
** Found on pump nameplate.
EXAMPLE:
Two No. 200 Clevis Pins for model DB2-C-175R,
serial number IP-0009 Milton Roy Pump.
3.3 RETURNING PUMPS TO THE FACTORY
Pumps will not be accepted for repair without a
Return Material Authorization, available from the
Factory Repair Department. Pumps returned to
the Factory for repairs should be clearly labeled
to indicate the liquid being pumped. Process liquid
should be flushed from the pump liquid end and oil
should be drained from the pump housing before
the pump is shipped.
Note:
Federal law prohibits handling of equipment that
is not accompanied by an OSHA Safety Data
Sheet (SDS). A completed SDS must be packed
in the shipping crate with any pump returned to
the factory. These safety precautions will aid
the troubleshooting and repair procedure and
preclude serious injury to repair personnel from
hazardous residue in pump liquid end. A Safety
Data Sheet must accompany all returns.
All inquiries or parts orders should be addressed
to your local Milton Roy representative or sent to:
www.miltonroy.com.
Item
Number
Part Name Qty
160 Crank Pin 1
165 Crank Pin Shoulder 1
142
Connecting Rod
Assembly (Includes
Spherical Bearing)
1
270 Friction Plug 2
152 Dowel Pin 1
210 Snap Ring 2
40 Shaft Oil Seal 4
112 Worm Shaft Bearing 2
211-0042-006 Journal Nut Tool 1
None
Coupling Insert for
300 Coupling
1
None LOCTITE
TM
Grade 222
0.10 cc
tube
Table 1. Drive Spare Parts.
SECTION 3 - MAINTENANCE INSTRUCTIONS-DRIVE SECTION