Ë
Free Position of Rotary Lever
—Attach the rotary lever to the shaft so that, in the free position, the lever
is at a right angle to the direction of relative movement between the switch and target (see FIGURE 3).
Ë
Angle of Switch
—Set a plunger switch so that the target and plunger move parallel to each other. It will be
approximately correct when properly installed on its mounting bracket, but may require fine adjustment.
With a roller plunger switch, make sure that the roller rotates in the direction that will accommodate
the movement of the target (not at a right angle to the target movement). Also, be sure that a replacement switch
has the roller oriented the same way as the switch it replaces (see FIGURE 5).
RIGHT!
Roller can’t absorb sideways movement
of target (wrong switch used).
RIGHT!
RIGHT!
Î
FIGURE 3
(MSSM0116AE)
Î
Free Position of Rotary Lever
Î
FIGURE 4
(MSSM0116AE)
Î
Plunger Switch Angle
Î
FIGURE 5
(MSSM0116AE)
Î
Roller Plunger Switch Angle
Содержание KURSPK0025
