Miller PipePro XC, Руководство пользователя

Страница: 27 / 72

OM-269631 Page 21
5-4. Remote 14 Accessory Receptacle Information
If a remote control is connected to the Remote 14 receptacle, the unit will automatically adjust output control to a primary/secondary configuration. In
this configuration, the Amperage Adjust knob on the unit becomes the primary and sets the maximum amperage output of the unit. The remote control
becomes the secondary and provides an amperage range of 0 to 100% based on the Amperage Adjust knob setting.
A J
B
K
I
C L N
H
D M G
E
F
Ref. 250 702-B
Socket* Socket Information
15 VOLTS DC
A 15 volts DC.
B Contact closure to A completes 15 volts DC
contactor control circuit.
REMOTE
CONTROL
C Output to remote control; +10 volts DC.
D Remote control circuit common.
E 0 to +10 volts DC input command signal from
remote control.
GND
K Chassis common.
*The remaining sockets are not used.
5-5. Power Source Remote 14 Wire Feeder Control Receptacle Information
Ref. 250 702-B
Remote 14 Feeder Control Socket* Socket Information
24 VOLTS AC
A, B 24 volts AC. Protected by supplementary
protector CB2.
C, D 24 volts AC return. Connected to chassis
common. Completes 24 volts AC power supply
circuit to feeder.
SERIAL
COMMUNICATION
J Isolated RS-485 (+) serial communication signal.
I Isolated RS-485 ( − ) serial communication signal.
H Isolated serial communication common.
POSITIVE VOLT SENSE
G Positive weld output voltage sense signal.
NEGATIVE VOLT SENSE
F Negative weld output voltage sense signal.
GND
K, N Chassis common.
*The remaining sockets are not used.