Miller Axcess E Dual, Руководство пользователя

Страница: 34 / 64

OM-248965 Page 30
A. System Reset
.
System Reset is not active when
Program Lock is enabled.
System Reset allows the operator to
reload factory program settings for all
eight active programs in the unit.
.
System configuration data will be
lost during the Reset operation.
Upper display push button LED
flashes to indicate this menu item
is available for selection. Press
the upper display push button.
CAC
ENBL
Trigger Control
Program
Process
Wire Type
Gas Type
Process Set up
Volts Time Arc Adjust
WFS Amps Arc Ctl
Sequence
Trigger Hold
Adjust Feeder Set Up
Trigger Control
Program
Process
Wire Type
Gas Type
Process Set up
Volts Time Arc Adjust
WFS Amps Arc Ctl
Sequence
Trigger Hold
Adjust Feeder Set Up
SYS
RST
Trigger Control
Program
Process
Wire Type
Gas Type
Process Set up
Volts Time Arc Adjust
WFS Amps Arc Ctl
Sequence
Trigger Hold
Adjust Feeder Set Up
RST
SYS
Rotate Adjust knob until System Reset
(SYS RST) appears on the display.
Rotate Adjust knob to select NO
or YES.
Trigger Control
Program
Process
Wire Type
Gas Type
Process Set up
Volts Time Arc Adjust
WFS Amps Arc Ctl
Sequence
Trigger Hold
Adjust Feeder Set Up
RST
NO
LED
Program 1 Pulse
.035 Mild Steel
90% Argon, 10% CO
2
Program 2 MIG
.035 Mild Steel
75% Argon, 25% CO
2
Program 3 Accu-pulse
.035 Mild Steel
90% Argon, 10% CO
2
Program 4 Pulse
.045 Mild Steel
90% Argon, 10% CO
2
Program 5 MIG
.045 Mild Steel
75% Argon, 25% CO
2
Program 6 Accu-pulse
.045 Mild Steel
90% Argon, 10% CO
2
Program 7 Pulse
.052 Mild Steel
90% Argon, 10% CO
2
Program 8 MIG
.052 Mild Steel
75% Argon, 25% CO
2
Unit will go through a soft boot and then
begin initialization (see Section 5-7).
During system reset the following factory
default programs are loaded into the unit:
RST
YES
Trigger Control
Program
Process
Wire Type
Gas Type
Process Set up
Volts Time Arc Adjust
WFS Amps Arc Ctl
Sequence
Trigger Hold
Adjust Feeder Set Up
Trigger Control
Program
Process
Wire Type
Gas Type
Process Set up
Volts Time Arc Adjust
WFS Amps Arc Ctl
Sequence
Trigger Hold
Adjust Feeder Set Up
PLS
WAIT
The Set Up push button LED flashes
indicating the unit is ready to perform
the system reset operation. Press the
Set Up push button.
Trigger Control
Program
Process
Wire Type
Gas Type
Process Set up
Volts Time Arc Adjust
WFS Amps Arc Ctl
Sequence
Trigger Hold
Adjust Feeder Set Up
CYCL
PWR
When System Reset is finished, the display
will show CYCL PWR for cycle power. Turn
the power source off and back on again.