OM-235 368 Page 6
3-2. Installing Headgear And Shroud
After installing shroud,
.
make sure there are no
gaps between shroud and
helmet edge.
1
Standard Headgear
2
Velcro Strip
3
Cooling System Headgear
4
Shroud
5
Velcro On Shroud
Remove knobs, o
−
rings, and
washers from standard
headgear. Remove headgear.
Use supplied towelette to clean
area inside helmet where Vel-
cro
®
will be installed. Allow
cleaned area to dry.
Remove backing from Velcro.
Install Velcro strip 5/8 in. (1.5
cm) from edge of quick release
Elite and Titanium helmets. For
all other helmets, install Velcro
3/4 in. (2 cm) from edge of hel-
met.
Position cooling system
headgear in helmet. Install
headgear mounting screw in
headgear bottom hole (quick re-
lease Elite and Titanium hel-
mets) or top hole (all other hel-
mets).
Secure headgear with knobs,
o
−
rings, and washers.
Align Velcro on shroud with Vel-
cro strip inside helmet. Press the
Velcro surfaces securely to-
gether.
Check for gaps between shroud
and helmet. Reposition shroud
and Velcro if necessary.
.
Remove shroud from hel-
met when using helmet with
the cooling system turned
off.
1
Ref. 231 425 / Ref. 804 111
2
3
Use bottom hole for
quick release Elite
and Titanium hel-
mets. Use top hole
for all other helmets.
4
5
