Miller Air Pak, Руководство пользователя, Страница: 21 / 86

OM-478 Page 17
4-3. Installing Precleaners, Exhaust Pipe, And Rain Cap
Stop engine and let cool.
Do not blow exhaust toward
air cleaner or air intake.
Remove rear, left side panel.
1
Air Cleaner
2 Precleaner
Remove tape from air cleaner
openings. Install precleaners on air
cleaners.
3
Exhaust Pipe
4 Muffler Extension
Remove tape from extension. In-
stall exhaust pipe over extension.
Secure exhaust pipe to top cover
using supplied hardware.
5
Rain Cap
Install cap so it opens toward front
of unit.
ST-153 652
1
2
3
5
4
Tools Needed:
1/2 in
4-4. Engine Prestart Checks
Check all fluids daily. Engine must
be cold and on a level surface.
Follow run-in procedure in engine
manual. If unburned fuel and oil col-
lect in exhaust pipe during run-in,
see Section 10.
1
Fuel
Add fresh fuel before starting engine
the first time (see maintenance label
for specifications). Fill fuel tank up to
1/2 in. (13 mm) from top to allow
room for expansion. Check fuel lev-
el on a cold engine before use each
day.
Do not run out of fuel or air enters
fuel system and causes starting
problems. See engine manual to
bleed air from fuel system.
2
Oil
After fueling, check oil with unit on
level surface. If oil is not up to full
mark on dipstick, add oil (see main-
tenance label).
To improve cold weather
starting:
Keep battery in good condition.
Store battery in warm area off
concrete surface.
Use fuel formulated for cold
weather (diesel fuel can gel in
cold weather). Contact local
fuel supplier for fuel in-
formation.
Use correct grade oil for cold
weather (see engine manual).
Ref. ST-153 653-A
Tools Needed:
3/8 in
Full
1/2 in
(13 mm)
Full
Diesel