Miller 907271, Руководство пользователя, Страница: 39 / 98

OM-222166 Page 33
Use the Cursor button to move the cursor to the desired selection (Type or Control TC), and press the Increase or Decrease
button to change the value to the desired setting. When the cursor is moved to the Type selection, pressing the Increase or
Decrease button changes the segment type to Step, Ramp, Soak, or End. The functions of each segment type are as follows:
S
Step increases the temperature in the part at full-programmed power. A maximum temperature of 1450
°
F (788
°
C) can be programmed.
S
Ramp increases or decreases the temperature in the part at a controlled rate in degrees per hour. A maximum temperature of 1450
°
F (788
°
C) and a maximum rate of 9999
°
F/hr (5555
°
C/hr) can be programmed.
S
Soak will hold the temperature for a programmed time. The minimum and maximum soak times are 0 and 100 hours or Extended.
S
End is programmed to indicate the completion of the cycle and termination of output power.
Step Function
When type is set to Step, the following screen appears on the display:
Mode.......: Custom Program
Segment....: 1
Type.......:>Step
Temperature: 600
Custom Program Screen
Use the Cursor button to move the cursor to the Temperature position and the initial temperature can be adjusted using the Increase
or Decrease button.
Pressing the Cursor button again automatically advances the program to the next segment number.
Ramp Function
When type is set to Ramp, the following screen appears on the display:
Mode.......: Custom Program
Segment....: 1
Type.......: Ramp
Temperature: 600 Ramp Rate: 600
_
/Hr
Custom Program Screen
Use the Cursor button to move the cursor to the Temperature or Ramp Rate position and use the Increase or Decrease
button to set the desired value.
When the cursor is in the Ramp Rate position, pressing the Cursor button again automatically advances the program to the next segment
number.