Miller 5 TURNTABLE, Руководство пользователя

Страница: 38 / 53

2. Release pressurized fluid from accumulator (see
Section 4-13).
3. Remove screws and cover from motor wiring
box.
4. Mark and disconnect input power leads from
motor leads.
5. Remove retainer nut from flexible conduit fitting.
6. Remove fitting and leads from wiring box.
7. Disconnect the
3 hydraulic hoses from fittings on
motor/pump adapter.
8. Remove the
4 bolts securing motor/pump and
reservoir assembly to turntable base.
9. Remove motor/pump and reservoir assembly
from turntable.
10. Remove hydraulic fittings from motor/pump
adapter.
11. Clean threads on hydraulic fittings removed in
Step 10, apply teflon tape to threads, and install
fittings on motor/pump adapter of replacement
motor/pump and reservoir assembly (see Figure
4-23).
Hydraulic
Line To
12. Install replacement motor/pump and reservoir
assembly on turntable base, and secure
assembly with the 4 bolts removed in Step 8.
13. Remove screws and cover from replacement
motor wiring box, and remove knock-out blank
in bottom of box.
14. Insert leads and conduit fitting in bottom hole of
wiring box, and secure fitting with retainer nut.
15. Connect input power leads to motor leads.
16. Install and secure wiring box cover.
17. Connect the 3 hydraulic hoses to hydraulic fit-
tings on motor/pump adapter (see Figure 4-23).
18. Fill reservoir with hydraulic fluid (see Section
4-4).
19. Manually run the program for rotating mounting
plate using the BLOCK FORWARD CON-
TINUOUS mode to check motor/pump and
reservoir assembly operation. Recheck
fluid
level
in reservoir after operation (see Section 4-4).
Base
Ret
TD-120
290
Figure 4
-
23. Location And Components Of Motor/Pump
And Reservoir Assembly
OM-890 Page 35