Instruction Manual
Page 11
CHAPTER 9
MAINTENANCE
9.0
Maintenance
Weld Roller:
To replace weld roller remove the fasteners on the drive shaft. Slide the weld roller off the drive
shaft and remove key from key-way. Installation is reverse of removal.
Warning! The operator must disconnect the power from the machine before proceeding.
Nozzle Position (Horizontal):
To adjust horizontal nozzle position loosen the four flat head bolts located on
the nozzle mounting bracket. When all four bolts are slightly loose, slide the nozzle into place while applying
downward pressure on the nozzle mounting bracket. Once the nozzle placement is satisfactory, tighten the
bolts in a crisscross pattern starting with one of the bolts closest to the element housing (Fig. 2).
Fig. 1
Fig. 2
