OM-216 655 Page 7
SECTION 3
−
INSTALLATION
3-1. Important Information Regarding CE Products (Sold Within The EU)
!
This equipment shall not be used by the general public as the EMF limits for the general public might be exceeded during welding.
This equipment is built in accordance with EN 60974
−
1 and is intended to be used only in an occupational environment (where the general public
access is prohibited or regulated in such a way as to be similar to occupational use) by an expert or an instructed person.
Wire feeders and ancillary equipment (such as torches, liquid cooling systems and arc striking and stabilizing devices) as part of the welding
circuit may not be a major contributor to the EMF. See the Owner’s Manuals for all components of the welding circuit for additional EMF exposure
information.
S
The EMF assessment on this equipment was conducted at 0.5 meter.
S
At a distance of 1 meter the EMF exposure values were less than 20% of the permissible values.
3-2. Serial Number And Rating Label Location
The serial number and rating information for this product is located on back
. Use rating label to determine input power requirements and/or rated output.
For future reference, write serial number in space provided on back cover of this manual.
Operating Temperature Range: 14
F (-10
C) to 104
F (40
C). Ratings were developed at an ambient temperature of 20
C to 25
C.
3-3. Specifications
Type of Input
Power
Welding Power
Source Type
Wire Feed
Speed Range
Wire
Diameter
Range
Welding
Circuit Rating
Overall
Dimensions
Weight
24 Volts AC Single
Phase
5 Amperes 50/60
Hz
Constant Voltage
(CV) DC with 14
pin and Contactor
Control
0 to 20 mpm
(0 to 788 ipm)
0.6 to 2.0 mm
(0.23 to 5/64 in.)
Max Spool Weight:
15 kg (33.0 lb.)
100 Volts,
500 Amperes,
100%
Duty Cycle
Length: 650 mm
(25.5 in.)
Width: 220 mm
(8.65 in.)
Height: 420 mm
(16.5 in.)
20.0 kg
−
Gross
18.0 kg
−
Net
3-4. Gun Recommendation Table
Process
Gun
GMAW
−
Hard or Cored Wires
Roughneck C-Series Guns: 300, 400, 500, And 600 Amp.
FCAW
−
Self-Shielding Wires
FC-1260 Or FC-1150
1
CV Welding Power Source with
14 pin Amphenol Receptacle
2
Interconnecting Control Cord
(Required)
3
Weld Cable (Required)
4
Work
3-5. Equipment Connection Diagrams
4
3
2
1
