Miller Electric Auto Invision II, Руководство пользователя

Страница: 116 / 132

OM-196 188 Page 110
1 Mig Type Display
With DVC Voltage Correction On,
the unit uses closed-loop feedback
or voltage sensing leads to
maintain set voltage parameters.
With DVC Voltage Correction Off,
feedback from the arc is not used
for closed-loop feedback to
maintain voltage parameters.
Feedback from the arc is still used
for other functions.
Be sure voltage sensing leads are
connected.
1
MIG
Voltage
Correction
> DVC Off
Access
> Mig Type
Aux Out
Voltage
14-4. Selecting Voltage Correction
Press Mode
Select
Increase
Access
Setup
Display
MIG
Voltage
Correction
> DVC On
1 Auxiliary Output
This output can be set to several
conditions:
On whenever the wire feeder is op-
erating
On during the welding arc until arc
goes out
On during the entire weld cycle
Off or never On.
1
Access
Mig Type
> Aux Out
Voltage
Aux
Turn On
> w/Feeder
14-5. Selecting Auxiliary Output
Access
Setup
Display
Press Mode
Select
Increase
Increase
Aux
Turn On
> w/Arc
Aux
Turn On
> w/Weld Cyc
Increase
Aux
Turn On
> Never
1 Voltage Feedback Display
The Internal setting allows the unit
to obtain voltage feedback directly
from the welding power source out-
put terminals.
When using the V. Sense setting,
arc voltage feedback is through the
voltage sense leads connected to
the feeder. Use this setting when
there is more than 50 ft (15 m) of
weld cable used or when using
Touch Sensor.
Mig Type
Aux Out
> Voltage
ArcStart
Control
Feedback
> Internal
1
Control
Feedback
> V Sense
14-6. Selecting Voltage Sensing Method
Access
Setup
Display
Increase
Press Mode
Select