background image

Transmitter:

MODEL: MGL-TX20

FCC ID: OYE-MGL-916

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATIONS IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS:

1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE

AND

2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.

Receiver:

MODEL: MGL-RX20

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which may be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1- Re-orient or relocate the receiver antenna

2- Increase the separation between the equipment and the receiver

3- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4- Consult the dealer or an experienced radio/TV technician for help.

Changes or Modifications Not Expressly Approved By The Party Responsible For Compliance Could Void
The User’s Authority To Operate The Equipment.

7-

FCC Compliance

P.O. Box 159 • West Grove, PA 19390 • 800-220-3343 • 610-869-4422 • Fax: 610-869-4423 • www.milleredge.com

6809 South Harl Ave., Suite A • Tempe, AZ 85283 • 800-887-3343 • 480-755-3565 • Fax: 480-755-3558

Содержание MGL-TX20

Страница 1: ... P O Box 159 West Grove PA 19390 800 220 3343 610 869 4422 Fax 610 869 4423 www milleredge com 6809 South Harl Avenue Suite A Tempe AZ 85283 800 887 3343 480 755 3565 Fax 480 755 3558 MGL K20_Inst_20160815 Model MGL K20 INSTALLATION INSTRUCTIONS IMPORTANT READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE BEGINNING INSTALLATION Kit Contents 1 MGL TX20 Transmitter unit 2 MGL RX20 Receiver unit 3 Receiver ...

Страница 2: ...mmed Channel 1 LED will be blinking rapidly indicating no Edge has been connected until your 10K Sensing Edge is connected to the Transmitter Press the Transmitter Test button again and note that the red LED on the Receiver turns on solid 3 4 If needed perform same steps for Channel 2 Up to 2 different Transmitters may be programmed per channel 3 5 To start over or erase programming press and hold...

Страница 3: ...s powered on Yellow LED Blinks off Indicates reception of message with our selected address On solid No Transmitters Learned Fast blink Termination fault Random blink Transmitters are Learned and sending Red LED Indicates safety device is active On solid Active Sensing Edge Fast blink Termination fault Medium blink Comunications fault Slow blink Low battery Off No faults Note Channel 2 LED will go...

Страница 4: ...nications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which may be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures 1 Re orient or relocate the receiver antenna 2 Increase ...

Отзывы: