3-
Learn Mode
3-1. Prior to mounting the Transmitter(s), remove the
cover(s) and insert the batteries, noting their polarity.
The green LED should blink once every second. Press
the Test button, next to the green LED, and note that
the green LED flashes rapidly 3 times.
3-2. To enter Learn mode for Channel 1, press and hold
the Learn button on the Receiver for ~2 seconds until
the yellow Status LED blinks rapidly and both Channel
1 and 2 red LEDs are on.
3-3. Press the Transmitter test button for ~2 seconds. Note
that the yellow Status LED and the red Channel 1
LED on the Receiver blink rapidly. Immediately release
the Transmitter Test button. Channel 1 is now
programmed. Channel 1 LED will be blinking rapidly
(indicating no Edge has been connected) until your 10K
Sensing Edge is connected to the Transmitter. Press
the Transmitter Test button again and note that the red
LED on the Receiver turns on solid.
3-4. If needed, perform same steps for Channel 2. Up to 2
different Transmitters may be programmed per channel.
3-5. To start over or erase programming, press and hold
both Learn buttons for ~3 seconds and release. Both
Channel 1 and 2 red LEDs will blink slowly. Restart the
Learn procedure.
P.O. Box 159 • West Grove, PA 19390 • 800-220-3343 • 610-869-4422 • Fax: 610-869-4423 • www.milleredge.com
6809 South Harl Ave., Suite A • Tempe, AZ 85283 • 800-887-3343 • 480-755-3565 • Fax: 480-755-3558
TOP LID
SCREWS
TRANSMITTER
PCB
STRAIN RELIEF
FITTING
(4) CORNER
MOUNTING HOLES
TEST BUTTON
REMOVABLE
TERMINAL BLOCK
MGL INSTALLATION
WITH GATE EDGE & OPERATOR
