3262019
8
1
3
2
4
5
6
FULL-BODY FALL ARREST HARNESS SYSTEM (LINEMAN BELT)
Figure 14
Threading Lineman Belt Buckle
A lineman belt has been included with your new Millennium to help insure your utmost safety while installing,
using, operating and/or removing your treestand. Your use of it as outlined here and elsewhere in this Instruction
Manual is crucial to its safe operation and the safe operation of your Millennium treestand.
When using lock-on style stands, it is necessary to use a full-body fall arrest harness lineman belt. These line-
man belts keep you safely attached to the tree while installing, using, operating and/or removing your lock-on
style treestand.
WARNING! You must wear and properly use the full-body fall arrest lineman belt which is provided with
this Millennium treestand. Failure to follow these instructions will result in serious injury or death!
STEP 1: Locate the full-body fall arrest harness lineman belt (refer to Figure 1). Please note, the lineman belt
is a two-piece design. One side short, with a sewn-loop tag-end and buckle (“buckle strap”). The other side, a
long strap with a tag-end and sewn-loop end (“long strap”). With your full-body fall arrest harness donned as
previously outlined in this Instruction Manual, slip the sewn-loop end of the buckle strap through the lineman belt
loop (refer to Figure 1) on either the left or right side of the harness. If you are right handed, it is recommended
you install the buckle strap on your right side. And vice versa if left-handed. This allows for ease-of-adjustment
when climbing.
STEP 2: With the buckle strap installed, repeat STEP 1 for the long strap side on the OPPOSITE lineman belt
loop.
STEP 3: Make certain both sides are cinched down tightly to the lineman belt loops.
WARNING! Both sides of the lineman belt must be tightly cinched down to the lineman belt loops.
Failure to do so will cause slippage leading to an unsafe condition. Failure to follow these instructions
will result in serious injury or death!
STEP 4: When ready to climb to your treestand installation height, wrap the long strap around the tree trunk,
threading it into the buckle strap as shown in Figure 14.
STEP 5: Adjust the lineman belt so it is a comfortable length while attached to the tree trunk by lengthening or shortening the tag-end
of the long strap.
Lineman Belt Donned
WARNING! A lineman belt that meets or exceeds industry standards recognized by the TMA (Tree-
stand Manufacturer’s Association) standards has been provided with this Millennium product(s).
You must wear/use it when installing, removing or using this Millennium product(s). Failure to
follow these instructions may result in serious injury or death!
You Must Stayed
Connected While Using
This Product!
